About this product

Polymer80 P80 PFS9 Complete PTL Frame

If you have been looking for a reliable starting point for your next build, the Polymer80 P80 PFS9 Complete PTL is a solid option that bridges the gap between a raw frame and a fully finished receiver. It arrives with the fire control unit (FCU) rails pre-installed and the frame roughly 80 percent machined, which means you handle the final shaping and finishing. This particular complete package includes the frame, jig, bits, and all necessary tooling, so you can focus on the build rather than hunting down individual parts.

Overview

The P80 PFS9 Complete PTL is designed for anyone who wants to assemble a custom pistol from the ground up without starting from a bare block of polymer. It is a compact, 9mm frame that accepts standard Glock 19 gen 3 parts. The “PTL” in the name refers to the “Pintail” variant, which features a slightly different rear rail geometry compared to earlier Polymer80 frames. This version ships with the front and rear locking block rails already installed, saving you the effort of pressing them in yourself. You still need to complete the frame by drilling the pin holes, removing the remaining polymer tabs, and finishing the grip stippling or texture to your preference.

Features & Specs

• Pre-installed front and rear locking block rails (FCU) eliminate the need for rail pressing and alignment
• Includes the complete jig, drill bits, end mill, and instructions for finishing the frame at home
• Accepts standard Glock 19 gen 3 slide, barrel, trigger group, and magazine components

The frame itself is molded from a reinforced polymer blend that holds up to regular range use. The pre-installed rails are made from hardened steel and mate with common slide assemblies without modification. You get three pin holes to drill for the trigger housing, slide lock, and trigger pin, plus the rear rail module is already fixed in place. The jig provided with the P80 PFS9 Complete PTL is reusable if you build additional frames later. Overall length of the frame is about 7.5 inches, and it accepts double-stack 9mm magazines with a standard capacity of 15 rounds (depending on your state laws).

Who It’s For

This frame is aimed at the hands-on shooter who enjoys the mechanical side of firearms. If you already know how to install a trigger, fit a slide, and check headspace, the P80 PFS9 Complete PTL gives you a clean slate to build a pistol exactly the way you want it. It is also a good choice for someone who has built a few AR-15s and wants to try a polymer pistol frame without jumping into a fully serialized receiver. Because the frame is not yet a firearm when shipped, you can have it delivered directly to your home in most states, though you will need to check your local laws before ordering. This kit is not for a first-time builder who has never used a drill press or hand file, but anyone with moderate mechanical ability and patience can finish it over a weekend.

Shipping & FFL

The P80 PFS9 Complete PTL is classified as a non-firearm frame blank and can be shipped directly to your residential address in most states. However, you must be at least 21 years old and legally allowed to possess a firearm frame in your jurisdiction. Some states and localities have specific restrictions on unfinished frames, including California, New Jersey, New York, Washington D.C., and others. It is your responsibility to confirm that receiving this item is legal where you live. No Federal Firearms License (FFL) transfer is required for this item at the time of purchase, but once you complete the frame, you are subject to all applicable federal and state laws regarding firearm ownership. We recommend consulting with a local attorney or your state police if you have any questions about the legality of building a pistol from this frame.